Daikin FTXR42EV1B Instrukcja Użytkownika Strona 6

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 30
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 5
5 English
Preparation Before Operation
To set the batteries
1. Press with a finger and slide the cover to take it off.
2. Set two dry batteries (AAA).
3. Set the cover as before.
Characters on the display will blink. Set the present time. (page 6.)
How to use
To use the remote controller, aim the transmitter at the indoor unit. If there is anything to block
signals between the unit and the remote controller, such as a curtain, the unit will not operate.
The maximum distance for communication is about 7m.
Do not drop the remote controller. Do not get it wet.
(Damage to LCD may occur.)
To fix the remote controller holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the remote controller holder to a wall or pillar using the
included screws.
3. Hook the holes on back of the remote controller to the protrud-
ing tabs on the remote controller holder.
Attach the Titanium apatite photocatalytic
air-purifying filter, deodorizing filter for streamer,
and air supply filter
(page 20, 23.)
Turn on the power breaker
Turning on the power breaker will cause the front panel and horizontal louver to open once
and then close again. (This is a normal procedure.)
CAUTION
During operation (i.e. when the panel is open or being opened or closed), do not touch the panel
with your hands.
ATTENTION
PRECAUTION
Wrap the terminals with tape to insulate them before discarding batteries. Mixing with other metals or batteries may cause heat, explosion or fire.
About batteries
The included batteries are provided to be used at first. Depending on when the air conditioner was manufactured, these batteries may run
out in less than a year.
We recommend replacing once a year, although if the remote controller display begins to fade or if reception deteriorates, please replace
with new alkaline batteries.
When replacing the batteries, use batteries of the same type, and replace the two old batteries together.
Batteries close to their expiration dates will have to be replaced sooner.
To prevent breakage or injury due to leaking or explosion, remove the batteries if the unit is not used for a long period of time.
About remote controller
Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult
the shop if that is the case.
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the shop.
Direct sunlight on the transmitter/receiver may cause the unit to work harder.
2
3
1
Position + and
– correctly!
Receiver
Remote
controller
holder
01_EN_3P177300-1.fm Page 5 Tuesday, May 30, 2006 10:08 AM
Przeglądanie stron 5
1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Komentarze do niniejszej Instrukcji

Brak uwag