Daikin FLK25BVMB Instrukcja Instalacji

INSTALLATION MANUALR410A Split SeriesModels FLXS25BVMB FLKS25BVMBFLXS35BVMB FLKS35BVMBFLXS50BVMB FLKS50BVMBFLXS60BVMB FLKS60BVMBFLX25BVMB FLK25BVMBFLX

English 6Indoor Unit InstallationCeiling Mounting1.Installing the suspension bolt.1) Install the suspension bolt so that it can support the indoor un

7 EnglishIndoor Unit InstallationWall Mounting3.Installation.• Install the indoor unit on the wall according to the installation drawings.1) Hang the

English 84.Installing indoor unit.1) Connect the extension auxiliary pipe ( , supplied) to the local pip-ing. (Applies to both ceiling mounting and w

9 EnglishIndoor Unit Installation6.Insulation of refrigerant pipes.After checking for refrigerant leaks• Joints in liquid pipe and the gas pipe must

English 10Refrigerant Piping Work, install as described in the installation manual supplied with the Multi outdoor unit.1.Flaring the pipe end.1) Cut

11 EnglishRefrigerant Piping Work2-2. Selection of Copper and Heat Insulation materials• When using commercial copper pipes and fittings, observe the

English 12Trial Operation and Testing1.Trial operation and testing.1-1 Measure the supply voltage and make sure that it falls in the specified range.

(1309)3P171284-2E M02B074KTwo-dimensional bar code is a code for manufacturing.HT00_CV_3P171284-2E.fm Page 2 Wednesday, October 9, 2013 3:49 PM

Umeda Center Bldg., 2-4-12, Nakazaki-Nishi,Kita-ku, Osaka, 530-8323 Japan DAIKIN INDUSTRIES, LTD.Low Voltage 2006/95/ECElectromagnetic Compatibi

Daikin Industries Czech Republic s.r.o.CE - DECLARATION-OF-CONFORMITYCE - KONFORMITÄTSERKLÄRUNGCE - DECLARATION-DE-CONFORMITECE - CONFORMITEITSVERKLAR

3SB65451-4.fm Page 2 Thursday, October 27, 2011 4:49 PM

1 EnglishSafety Precautions• Read these Safety Precautions carefully to ensure correct installation.• This manual classifies the precautions into WAR

English 2Accessories – • The extension auxiliary pipe is not included for FLX(S)25, FLX(S)35, FLK(S)25 and FLK(S)35.Choosing an Installation Si

3 EnglishBefore Installing the Indoor Unit1.Perform the following before installing the indoor unit.1) Open the air inlet grille and the screw cover,

English 4Indoor Unit Installation DrawingsO NOFF50mm or more from floorDScrews (Field supply: M3 × 20L)ECaulk pipe hole gap with putty. Cut thermal

5 EnglishIndoor Unit Installation Drawings1.Ceiling mounting.2.Wall mounting.Local drain pipeCeilingWall*1 Determine the position of the feed-through