Daikin FHQ50BUV1B Instrukcja Instalacji Pobierz pdf (Strona 24)

21 English

Ta bl e 9

NOTE

1. In case wired remote controller. Press the INSPECTION /TEST OPERATION button on remote

controller, “ ” starts flashing.

2. Keep down the ON/OFF button for 5 seconds or longer in the inspection mode and the above trouble his-

tory disappears, after the trouble code goes on and off twice, followed by the code “00”(normal).

The display changes from the inspection mode to the normal mode.

3. Depending on the model or the conditions, it may carry out an emergency shut-down.

If the HBP(H2P) is off, the branch wiring between each of the indoor and outdoor units may either be incorrectly

connected or broken. Before taking any of the diagnostic steps listed above, check the branch wiring.

If the HBP(H2P) is off on an inverter, there is a possibility that the fuse on the outdoor unit’s PC board is

burnt out.

5. Cut off the power and wait for 5 seconds or longer. Turn on the power again and see if the LED is in the

same state again.

10-3 MALFUNCTION CODE

• For places where the malfunction code is left blank, the “” indication is not displayed. Though the sys-

tem continues operating, be sure to inspect the system and make repairs as necessary.

• Depending on the type of indoor or outdoor unit, the malfunction code may or may not be displayed.

Microcomputer

normal monitor

Transmission

normal monitor

Details

HAP(H1P) HBP(H2P) FAY-L, FAYP-L, FAQ-BUV1B

Indoor unit is normal Diagnose the outdoor unit

Miswiring between the indoor and outdoor units

If the outdoor unit HAP(H1P) does not light, diagnose the outdoor

unit. If it is flashed, it is due to either miswiring or malfunction of the

indoor or outdoor unit PC board assembly.

(NOTE 4)

Malfunction of the indoor unit PC board (NOTE 5)

Abnormal power supply, malfunction of PC board assembly or

disconnection between the indoor and outdoor units (NOTE 5)

Code Malfunction/Remarks

A1 Indoor unit’s PC board faulty

A3 Drain water level abnormal

A6 Indoor fan motor overloaded, overcurrent or locked

Humidifier faulty

Air cleaner faulty

Only the air cleaner does not function.

Type set improper

Capacity data is wrongly proset. Or there is nothing programmed in the data hold IC.

C4 Sensor for heat exchanger lamp is fault

C9 Sensor for suction air lamp is fault

Sensor for remote controller is fault

The remote controller thermistor does not function, but the system thermo run is possi-

ble.

E0 Action of safety device (outdoor unit)

E1 Outdoor unit’s PC board faulty (outdoor unit)

E3 High pressure abnormal(outdoor unit)

01_EN_3P083811-3T.fm Page 21 Friday, September 3, 2004 10:17 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Komentarze do niniejszej Instrukcji

Brak uwag

Daikin FHQ50BUV1B Instrukcja Instalacji Strona 24

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Klimatyzatory typu split Daikin FHQ50BUV1B